Back to lookup

Generic gasoline powertrain DTC / Generic automatic-transmission controls

P0750: Shift solenoid A malfunction

The controller detected a malfunction associated with shift solenoid A operation.

Generic definition
P0700
P0730

Likely cause paths · unconfirmed

A possible sensor, wiring, or control issue

Speed signals, connectors, solenoid circuits, or control inputs can affect shift behavior; a code does not prove a sensor or solenoid failed.

  • Record gear display, warning lamps, and when engagement changes.
  • Save transmission and engine codes before clearing.

A possible fluid, hydraulic, or mechanical transmission condition

Fluid condition, hydraulic pressure, clutch elements, or internal wear may cause a performance or ratio concern and require vehicle-specific testing.

  • Do not perform a deliberate slip or shift road test.
  • Record leaks only from a safe position; do not touch hot parts.

Likely causes and repair directions are general, conditional orientation. The SAE citation supports the generic DTC definition only; it does not validate these causes, tests, repairs, or fitment to a particular vehicle.

Conditional likely repairs

A code describes a monitored condition; it does not prove a failed part. Use these directions only after confirming the cause.

If confirmed: A possible sensor, wiring, or control issue

If circuit and scan-data tests confirm a signal or control fault, repair the isolated wiring or component using OEM information.

Evidence to confirm

  • Electrical and live-data tests isolate the fault.
  • The shift/gear monitor passes after repair.

If confirmed: A possible fluid, hydraulic, or mechanical transmission condition

If the OEM fluid or mechanical test confirms a transmission fault, service the verified cause using the specified fluid and procedure; do not add fluid by guesswork.

Evidence to confirm

  • Fluid is checked by the specified temperature/level procedure or mechanical testing isolates the fault.
  • Operation is verified without slip or a returning fault.

Guided evidence checks

  1. 01

    Record what happened

    Note when the warning appeared, what the vehicle was doing, and any recent service or change. Do not deliberately recreate an unsafe symptom.

  2. 02

    Make only a safe visual check

    Record the warning, gear display, and whether the vehicle engages or slips. Do not crawl under the vehicle or check hot fluid roadside.

  3. 03

    Preserve scan-tool evidence

    Qualified technician

    Save all transmission and engine codes, status, freeze-frame, and available speed/gear data before clearing.

  4. 04

    Confirm the system path

    Qualified technician

    A qualified technician should verify fluid type/level by OEM procedure and test speed sensors, wiring, solenoids, and mechanical operation.

Code-specific symptom note

  • Code-specific symptoms are not verified by the cited definition. Record the driver’s actual observations separately.

This generic code reference is not an OEM procedure, does not confirm that a DTC applies to a particular make/model/engine, and is not a repair diagnosis. Follow vehicle-specific service information or consult a qualified technician.